Nissan Titan Running Board Installation Tutorial

Video Transcript

Hey everyone,

In this Titan Tutorials video, we’re going to be showing you how to install running boards on your Nissan Titan.

These are the Tyger Star Armor running boards, nerf bars, whatever you’d like to call them.

Let’s get right into it, we’re going to show you how to install these on your Titan.

Okay so we’re here under the body of the driver’s side. Next to these factory threaded screws, we’re going to look for these plugs that are right here. These are just plastic clips that come pre-installed. You can get a flat head screwdriver and pop those right off. You’ll do the same for the one that is here and across the body as well.

Once you take those clips off, the side rails are going to mount with two points of contact. The first is going to be here where we removed that clip. So into there you’re going to insert a 13mm bolt that’s just going to fit right into here. You’ll apply a flat washer and a lock washer, tighten that up.

The second point of contact is up here where the factory threaded screw is. You’ll again apply a washer, and a 13mm nut that comes with the packaging. So you’ll tighten both of those and then you’ll do that for the other points of contact along the vehicle as well.

You’ll tighten this 13mm bolt with the lock washer and the flat washer. Then up here at the top, where the factory threaded screw was, you’ll tighten that as well, and then you’re all set up.

When it’s all said and done you’ll have six points that you’ll secure. The two at the front, two in the middle, then two at the back of the vehicle.

That’s all you need to do to install side rails on your Nissan Titan.

Let’s get out from under the vehicle and see how it looks installed.